You probably have gathered that I am better at racing cars than fixing them. This is a con rod bolt out of my BCM motor which is a 6 cyl Vauxhall 2.2L PA S (1957).
It is not Vauxhall as when it was re built we did not use Vauxhall rods.
The bolt is 52mm from under the head to tip of thread, has a 5/16 shaft to a 5/16 UNF thread.
Where do I go to get 12 replacements?
Someone said ARP in the States but does anyone in NZ supply or source bolts?
Any response appreciated.
Also if anyone has a PA motor under the bench then my hand is up as I am running out of bits - down to my last head and current block is out +60 thou.
Chris Read - Arrowtown